Honeywell HF800 Series User Manual

56
Addenda Required: When Required is set, the HF800 only reads UPC-A bar codes
that have addenda.
Addenda Separator: When this feature is On, there is a space between the data
from the bar code and the data from the addenda. When turned Off, there is no
space.
UPC-E
Click the “UPC-E” in the left list then all its related parameters will be shown on the
right.
Redundant times: output the decode result only when got identical barcodes
information for specific times.
E0 / E1 Decoding: Most U.P.C. bar codes lead with the 0 number system. For these
codes, use UPC-E0.If you need to read codes that lead with the 1 number system,
use the UPC-E1 On selection.
E Expand: UPC-E Expand expands the UPC-E code to the 12 digit, UPC-A format.
E Check Digit Transmit: Check Digit specifies whether the check digit should be
transmitted at the end of the scanned data or not.
UPC-E0 Leading Zero: This feature allows the transmission of a leading zero (0) at
the beginning of scanned data.
2/5 Digit Addenda: This selection adds 2 or 5 digits to the end of all scanned UPC-E
data.
Addenda Required: When Required is set, the HF800 only reads UPC-E bar codes
that have addenda.
Addenda Separator: When this feature is On, there is a space between the data
from the bar code and the data from the addenda. When turned Off, there is no
space.

Honeywell HF800 Series Specifications

General

Brand	Honeywell
Model	HF800 Series
Category	Barcode Reader
Language	English