To Next Page

To Previous Page

If device is connected via serial port, be sure to select

correct parameters (Data Bits/Stop Bits/Parity).

Reading failure

- Tune the Acquisition Delay on Trigger, if the moving

code is out of the reader field of view;

- Set the streaming presentation/presentation

Operating Mode if no external trigger source i

available;

- Fi

ne tune the Image Setup to improve the code

image quality;

- Check the code parameter settings in the Symbology

Setup step: 2D , Linear, and Stacked Linear;

- View the full resolution code image to check the

printing or marking quality.

Unable to trigger the

device with external

trigger source or soft

trigger

Is the external sensor wiring correct? Check the I/O

input according to external sensor parameter.

Communication:

device is not

transmitting

anything to the host.

Make sure the wire is properly connected.

Make sure the configuration is related to the actual

working mode.

Are the host serial port settings the same as the reader

serial port settings?

Communication:

data transferred to

the host

are incorrect.

In the DataMax

, Data Formatting step check the

settings of Prefix and Suffix String and other

parameters.

Honeywell HF800 Series User Manual

Questions and Answers: