Honeywell NetAXS - Network Tab; Figure 2-3: Configuration > System > Network Tab

2-8 www.honeywell.com
Configuring via the Web Server
Configuring the System
2.2.3 Network Tab
Your NetAXS™ panel is physically configured in one of a number of possible
network configurations. See the “System Configuration” section in the NetAXS™
NX4L1 Installation Guide or NetAXS™ NX4S1 Installation Guide for illustrations of
the supported network configurations. For the panel to function in any of these
configurations, the other panels and devices in the network must know the panel’s
network addresses.
Click
Network to display the Network tab:
Figure 2-3: Configuration > System > Network Tab
The Network tab enables you to:
• View the panel’s MAC address.
• View and edit the panel’s IP address.
• View and edit the panel’s subnet mask.
• View and edit the panel’s default gateway.