Configuring via the Web Server
Configuring the Doors
NetAXS™ Access Control Unit User’s Guide, Document 800-00233, Revision A 2-21
2.4 Configuring the Doors
Each NetAXS™ panel supports four doors. For each door, you must configure the readers, inputs, and
outputs.
At
Configuration > Doors in the task menu at the left margin of the NetAXS™ screen, click 1 to display
the Door Configuration screen for door 1. Follow the same procedures below for doors 2, 3, and 4 for
each panel.
2.4.1 Reader Tab
A reader is a device that reads cards and either grants or denies access at the door.
Click the
Reader tab:
Figure 2-10: Configuration > Doors > Reader Tab
To Next Page
Loading...
