Honeywell NetAXS - Connecting to the Web Server; Overview; Connecting to the NetAXS Web Server

Pro-Watch Software Suite Guide, Document 7-901071, Revision A 1-1
1
Connecting to the Web Server
In this chapter...
1.1 Overview
A NetAXS™ access control system consists of a host system and NetAXS™ access
control units that exceed existing N-1000-III/IV, Pro Series specifications and
approvals, and that communicate with each other and with a variety of input and
output devices. Each access control unit, or panel, has four reader ports. See the
NetAXS™ NX4L1 Installation Guide or NetAXS™ NX4S1 Installation Guide to view
illustrations of the supported NetAXS™ system configurations.
You access the NetAXS™ access control unit either through a host software system or
by connecting to the NetAXS™ web server by an Ethernet connection. This chapter
describes how to connect to the NetAXS™ web server. Chapter 2 describes how to
use the NetAXS™ web interface after you are connected to the NetAXS™ panel
through the NetAXS™ web server. Chapter 3 describes how to use the web server
interface.
Overview 1-1
Connecting to the NetAXS™ Web Server 1-2