Honeywell NetAXS - Outputs Tab; Figure 2-20: Configuration > Other I;O & Groups > Outputs Tab

Configuring via the Web Server
Configuring Other I/O & Groups Tab
NetAXS™ Access Control Unit User’s Guide, Document 800-00233, Revision A 2-46
2.7.2 Outputs Tab
This tab enables you to configure the four NetAXS™ auxiliary outputs (outputs 5-8) that are
physically located on the panel board, and the outputs on downstream 2/16 MIRO boards
daisy-chained to Terminal Block 10. A NetAXS™ panel supports a maximum of four 2/16 MIRO
boards, and each board provides two inputs and 16 outputs. The downstream outputs are numbered
17-81.
Click
Outputs to display the Auxiliary Output screen for the on-board outputs:
Figure 2-20: Configuration > Other I/O & Groups > Outputs Tab