Honeywell NetAXS - Monitoring Outputs

4-10 www.honeywell.com
Monitoring NetAXS™ Status
Monitoring Outputs
4.5 Monitoring Outputs
An output is an output device that changes its normal state when it is energized, pulsed, or time-zone
controlled. For example, a successful card read at a reader pulses a door lock. The lock changes its
normally locked state to an unlocked state and the cardholder opens the door.
A NetAXS™ panel supports one output for each of its four doors. The panel also supports four
additional outputs for auxiliary devices and 64 downstream outputs. Outputs can be configured singly
as discrete outputs (see “Output Tab“ on page 28 and “Outputs Tab“ on page 46) or collectively as a
group of outputs (“Groups Tab“ on page 49).
Note: The Pulse and Restore to Time Zone buttons will be greyed out if no outputs are attached.
Click
Status > Outputs to display the Discrete tab of the Output Status screen:
Figure 4-6: Status > Outputs > Discrete Tab
Figure 4-7: Status > Outputs > Groups Tab
Click
Status > Outputs > Groups to display the Groups tab of the Output Status screen: