Honeywell NetAXS - Page 97

Monitoring NetAXS™ Status
Monitoring Outputs
NetAXS™ Access Control Unit User’s Guide, Document 800-00233, Revision A 4-11
The Output Status tab enables you to:
• View the current status of each output in the Discrete tab (Energized or
De-energized).
• View the current status of each output group in the Groups tab.
• Energize or de-energize any output or group indefinitely.
• Pulse any output. This energizes the output or group for a configured period of
time (see “Output Tab“ on page 28).
• Restore the output to its configured time zone. A time zone is a specified time
period during which the output will be energized. (see “Configuring Time
Management“ on page 15).
Steps:
1. To energize an output or group of outputs for an indefinite period of time, click
the
De-energized button to display a prompt. Click OK to complete the change
to “Energized.”
To de-energize an output or group of outputs for an indefinite period of time, click
the
Energized button to display a prompt. Click OK to complete the change to
“De-energized.”
2. To Pulse an output or group of outputs for the configured period of time, click
the
Pulse button to display a prompt. Click OK to start the pulse. Note that the
Pulse button will be greyed out if no output is attached.
3. To re-set the output behavior according to its configured time zone, click the
Restore to Time Zone button to display a prompt. Click OK to restore the time
zone. Note that the Restore to Time Zone button will be greyed out if no output
is attached.