Honeywell NetAXS - Page 42

2-24 www.honeywell.com
Configuring via the Web Server
Configuring the Doors
2. Click Card Formats at the top of the tab. A card format tells the panel how the card number will
be read. The panel supplies the format to the card readers. Then, the card readers can correctly
read the card.
Anti-Passback Configures the anti-passback feature, which prevents an entrant
to an area from passing his card back to another potential
entrant. Note that anti-passback must first be enabled at the
Configuration > System > General screen (see General
Tab, page 3).
Enabled – Enables the anti-passback feature.
Hard – Does not allow a second entry on the same card without
an exit.
Soft – Allows a second entry on the same card without an exit;
however, an event is generated that indicates the second entry.
Out – Applies to readers located inside the area. Cardholders use
these readers when attempting to exit the area.
In – Applies to readers located outside the area. These are
readers that cardholders use when attempting to enter the area.
Table 2-4: Configuration > Doors > Reader Tab Descriptions (continued)
Setting Description