Honeywell Searchpoint Optima Plus - Page 23

MAN0905_Issue 7_07/17 Searchpoint Optima Plus with optional HART
®
output
Operating Instructions
2108M0550
23
US Duct Mounting Kit – NPT Threads
Note:Inordertomakeuseofthegassingpointsprovided,theSearchpointOptimaPlusunitmustbe
factoryttedwiththeRemoteGassingCell(2108B0240).
Note:CSAapprovalonlyappliesforductowrateslessthan5m/s.
Theductmountingkitisassembledandinstalledontoaductasbelow:-
1. Cut a square 6” by 6” hole in the duct wall. Drill the holes required to attach the mounting plate to the
duct wall.
2. Place the Searchpoint Optima Plus unit on the side of the mounting plate where the threaded bushes
protrude and feed the wires through the central hole.
3. Locatetheunit’sbossinthecentralholeandfeedtheunit’swiresthroughthechosencableentryon
the junction box.
3. Mechanical Installation
Note:Dimensionsshown
in inches.