Honeywell Searchpoint Optima Plus - 11.3 Searchpoint Optima Plus User Interface

MAN0905_Issue 7_07/17 Searchpoint Optima Plus with optional HART
®
output
Operating Instructions
2108M0550
51
1 Device Setup
1 User Level 1
2 User Login
3 Unit Status
4 Gas Conguration
5 Test
6 Calibrate
7 User Conguration
8 Assembly Details
9 Device Info
1 HART During Fault xxxx
2 Inhibit Current xxxx
3 Warning Current xxxx
4 Overrange Current xxxx
5 Set Time (24 hour)
6 Set Date (dd/mm/yyyy)
7 Change Password
1 Device Setup
1 User Level 1
2 User Login
3 Unit Status
4 Gas Conguration
5 Test
6 Calibrate
7 User Conguration
8 Assembly Details
9 Device Info
1 Cong Revision xxxx
2 HART Address xxxx
3 Description ??
4 Assembly Date ??
5 Assembly Number ??
6 Device Tag ??
7 Transmitter ID
1 Device Setup
1 User Level 1
2 User Login
3 Unit Status
4 Gas Conguration
5 Test
6 Calibrate
7 User Conguration
8 Assembly Details
9 Device Info
1 Loop Current Mode xxxx
2 Num req preams xxxx
3 Num resp preams xxxx
4 Dev id xxxx
5 Universal rev xxxx
6 Fld dev rev xxxx
7 Software rev xxxx
8 Hardware rev xxxx
11.3.3 Menu Navigation
Menu options can be selected by highlighting the option and pressing Enter, by pressing the number of the
option, or by double clicking on the option. For more information on how to select menu options please see
theinstructionsfortheHART
®
host device being used.
11.3.4 Error Reporting
SearchpointOptimaPlusimplementsHART
®
protocolCommand48,meaningthatifanyeventisdetected
intheunitwhileaHART
®
host is connected, it will be reported immediately. Therefore warning messages
may pop up during other operations.
11. Use of the HART
®
Communications