Honeywell Searchpoint Optima Plus - 12.3 User Configuration

MAN0905_Issue 7_07/17 Searchpoint Optima Plus with optional HART
®
output
Operating Instructions
2108M0550
54
9. Type in the new password and press Enter.
Note:SomeHART
®
handheld devices contain a default password or hold a previously used password.
Ensure that the desired password is typed in before pressing Enter.
10.Thedisplayshowsaconrmationmessage,pressOK.
11.ProceedtoCongureHART
®
Operation during Fault, step 3, or press Back to return to the Device
Setup menu.
12.3.2 Congure HART
®
Operation during Fault
Searchpoint Optima Plus is shipped with the Fault output current level set to < 1 mA. If the unit enters
aFaultcondition,theHART
®
communicationswillnotwork(HART
®
communications require > 1 mA to
operate).TheFaultoutputcurrentlevelcanbechangedto1mAsothatHART
®
communications remain
active during a Fault condition.
1. Select Device Setup.
2. Select User Conguration.
3. Select HART During Fault.
4. Select HART ACTIVE and press Enter.
5. Press Send to send the information to Searchpoint Optima Plus.
6. Proceed to Set the Time and Date, step 3, or press Back to return to the Device Setup menu.
12.3.3 Set the Time and Date
SearchpointOptimaPlushasarealtimeclock,whichisfactorysettoUKtime.Itcanbeadjustedtolocal
time.
1. Select Device Setup.
2. Select User Conguration.
3. Select Set Time.
4. Enter the correct time (24 hour format) and press Enter.
5. Thedisplayshowsaconrmationmessage,pressOK.
6. Select Set Date.
7. Enterthecorrectdate(dd/mm/yyyyformat)andpressEnter.
8. Thedisplayshowsaconrmationmessage,pressOK.
9. ProceedtoCongureWarning,InhibitandOverrangeSignalLevels,step3,orpressBack to return
to the Device Setup menu.
12. Commissioning using
HART
®
Communications