50
XLS80e Fire Alarm Control Panels
Honeywell, Issue 9
March 2007
5.3.5 End of Learn Process
1 Press to confirm the changes.
2 The configuration data is written to the
panel’s memory.
If no changes were made, the message shown
at left is displayed for a short time.
5.4 Change Zone Number
This option is available at access level 3A if
network zones are being used. An entire zone
can be renumbered (i.e. all devices moved to
another, unoccupied zone). It can be used to
overcome duplicate network zones.
Note: If the entered NEW zone already
contains devices, ‘This zone already in
use in this panel’ is displayed. Enter the
number of an unoccupied zone.
IF THE PANEL HAS FOUND AND CONFIGURED
ANY DIFFERENCES:
To Next Page
Loading...
Need help?
General
