horsch LEEB LT - Cleaning Spraying Mixture Container

3.2.3.6 Cleaning spraying mixture container
b
e
a
f
g
c
d
The function pumps fresh water into the
spraying mixture container for internal clean-
ing to prevent drying of the spraying mixture.
The function is enabled from a travel speed
of 3 km/h and runs in the background of the
entire machine functions. In addition, the 󰘰lling
level of the spraying mixture container must
lie below the internal cleaning nozzles and the
inside wings must be unfolded.
(a) Start/stop cleaning of spraying mixture
container
(b) Manual cleaning of the spraying mixture
container when the machine is stopped
(no start conditions required)
¾ The softkey must be pressed and held
for this period.
(c) Interval
¾ Time in minutes after which the cleaning
process shall be repeated
(d) Cleaning time
¾ Time in seconds of the duration of the
cleaning process
(e) One-time cleaning process when switch-
ing from 󰘰eld to road travel
¾ If a checkmark is placed in this 󰘰eld, the
cleaning process runs through once after
the inside wings were folded and the travel
speed is greater than 3 km/h.
(f) Filling level spraying mixture container
(g) Filling level fresh water tank
NOTE
The function remains active until the spraying mixture container or the fresh water tank (below the
reserved residual quantity for outside cleaning) is empty.
The function remains active in the background until the start conditions are met again.
22 23