3.2.11 Speed
F
When travelling backwards, an “R is displayed
below the bar graph.
a
c
b
d e f
g
h
(a) Permissible minimal speed in spraying
operation, depending on nozzle proles
(b) Permissible maximum speed in spraying
operation, depending on nozzle proles
(c) Current speed
The red bars indicate areas (depending on
the automatic nozzle selection) that shall/
must not be reached during operation.
(d) ISOBUS - speed via GPS on the tractor
(e) ISOBUS - speed sensor on the tractor
(f) ISOBUS - speed via wheel sensor on
the tractor
(g) Speed signal from the wheel sensor of
the sprayer
(h) Input eld for the simulated speed
¾ Functions with a speed entered as con-
stant can be simulated.
¾ Entering a negative simulation speed is
also possible.
NOTE
The simulation speed can also be used as emergency program if no other speed can be selected.
The speed-dependent calculations are based on the respective speed source selected at the time.
If the simulation speed is used, the set speed must also be travelled exactly during work. Otherwise,
the application quantity cannot be applied correctly!
No automatic steering is possible with the simulation speed!
30 31
To Next Page
Loading...
