HP 12500 Series User Manual

104
Category Card model Description
Applicable 12500
chassis
Supported
q
uantit
y
LST1FW3A1 Firewall card All S12500 models As required
NOTE:
• HP recommends that you install two MPUs for redundancy, and install all switching fabric modules to
your switch. The active MPU and standby MPU must be the same model, and the switching fabric
modules used on a 12500 switch must be the same model.
• The LST1XP8LEB1, LST1XP8LEC1, LST2SF08C1, LST2SF18C1, LST1XP16LEB1, and LST1XP16LEC1 are
supported by Release 1728 and above.
• OAA cards are not supported by R7XXX.
For more information about the 12500 card LEDs, see "Appendix B LEDs."
MPUs
Table 36 MPU specifications
Item Specifications
Model LST2MRPNC1
CPU MPC8548+MPC8544 (FFDR CPU)
Flash 128 MB
Boot ROM 4 MB
NVRAM 1 MB
SDRAM (DDR2) 4GB
CF card 1 GB
Interfaces
• One console port
• One AUX port
• One network management port
• One CF card slot
• Two USB ports—HOST and DEV (DEV is not supported.)
• Two MCC GE ports (no supported)
Switching fabric modules
Table 37 Switching fabric module specifications
Model CPU Boot ROM SDRAM
Applicable switch
models
LST1SF08B1 MPC8248 4 MB 128 M 12508
LST1SF18B1 MPC8248 4 MB 128 M 12518
LST2SF08C1 MPC8248 4 MB 128 M 12504 and 12508
LST2SF18C1 MPC8248 4 MB 128 M 12518

HP 12500 Series Specifications

General

Brand	HP
Model	12500 Series
Category	Switch
Language	English