HP 12500 Series User Manual

67
Line-card power status:
Slot Board-Type Watts Status
---- --------------- ----- ------
2 None -- Absent
3 None -- Absent
4 None -- Absent
5 LST1GT48LEC1 190 On
6 None -- Absent
7 None -- Absent
8 None -- Absent
9 None -- Absent
Configuring temperature thresholds for a card
You can set temperature thresholds for a card. When the temperature reaches the threshold, the switch
generates alarms.
Configuring temperature thresholds for a card
Ste
p
Command
1. Enter system view.
system-view
2. Configure temperature alarm
thresholds for a card.
• In standalone mode:
temperature-limit slot slot-number { inflow | hotspot | outflow }
sensor-num lowerlimit warninglimit [ alarmlimit ]
• In IRF mode:
temperature-limit chassis chassis-number slot slot-number { inflow |
hotspot | outflow } sensor-num lowerlimit warninglimit [ alarmlimit ]
Displaying the temperature information on your switch
Use the display environment command to display the temperature information of the sensors on the cards,
including the current temperature and temperature thresholds.
# Display the temperature information of the cards on the switch.
<Sysname> display environment
• In standalone mode:
System temperature information (degree centigrade):
-------------------------------------------------------------------------------
Slot Sensor Temperature LowerLimit WarningLimit AlarmLimit ShutdownLimit
1 inflow 1 21 -25 70 80 N/A
1 outflow 1 24 -15 70 85 N/A
1 hotspot 1 27 -15 75 85 N/A
5 inflow 1 27 -20 65 85 N/A
5 outflow 1 27 0 70 85 N/A
5 hotspot 1 30 -10 70 80 N/A

HP 12500 Series Specifications

General

Brand	HP
Model	12500 Series
Category	Switch
Language	English