130
Figure 88 Affixing a label
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate should be on
top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure the
label is facing out, as shown in Figure 89.
Figure 89 Affi
xed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a signal cable. For more
information, see "Affixing a label to a signal cable." F
or the example of affixed labels, see Figure 87.
TO:
B03
–48V2
To Next Page
Loading...
