153
Ste
Command
Remarks
3. Enable the voice VLAN
security mode.
voice vlan security enable
Optional.
By default, the voice VLAN security
mode is enabled.
4. Add a recognizable OUI
address.
voice vlan mac-address oui mask
oui-mask [ description text ]
Optional.
By default, each voice VLAN has
default OUI addresses configured.
For the default OUI addresses of
different vendors, see Table 14.
5. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
6. Configure the link type of the
Ethernet interface.
• port link-type trunk
• port link-type hybrid
Use one of the commands.
7. Configure the port to operate
in automatic voice VLAN
assignment mode.
voice vlan mode auto
Optional.
By default, the automatic voice
VLAN assignment mode is
enabled.
The voice VLAN assignment modes
on different ports are independent
of one another.
8. Enable the voice VLAN
feature.
voice vlan vlan-id enable
By default, the voice VLAN feature
is disabled.
Configuring a port to operate in manual voice VLAN
assignment mode
Configuration restrictions and guidelines
• You can configure different voice VLANs on different ports at the same time. However, you can
configure one port with only one voice VLAN, and this voice VLAN must be a static VLAN that
already exists on the device.
• You cannot enable voice VLAN on the member ports of a link aggregation group. For more
information about the member ports, see "Configuring Ethernet link aggregation."
• To make voice VLAN take effect on a port that is enabled with voice VLAN and operates in manual
voice VLAN assignment mode, you must assign the port to the voice VLAN manually.
Configuration procedure
To set a port to operate in manual voice VLAN assignment mode:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable the voice VLAN
security mode.
voice vlan security enable
Optional.
By default, the voice VLAN security
mode is enabled.
To Next Page
Loading...
Need help?
General