46
Ste
Command Remarks
2. Enter aggregate interface view.
• interface bridge-aggregation
interface-number
N/A
3. Restore the default settings for the
aggregate interface.
default
N/A
Configuring load sharing for link aggregation
groups
Configuring load-sharing criteria for link aggregation groups
You can determine how traffic is load-shared in a link aggregation group by configuring load-sharing
criteria. The criteria can be source/destination MAC addresses, source/destination service port numbers,
ingress ports, source/destination IP addresses, or any combination.
You can configure global or group-specific load-sharing criteria. A link aggregation group preferentially
uses the group-specific load-sharing criteria. If no group-specific load-sharing criteria are available, the
group uses the global load-sharing criteria.
NOTE:
The load sharin
criteria confi
uration applies to only unicast packets, and can chan
e the load sharin
criteria for unicast packets. Broadcast packets and multicast packets always use the default load sharin
criteria.
Configuring the global link-aggregation load-sharing criteria
Ste
Command Remarks
1. Enter system
view.
system-view N/A
2. Configure the
global
link-aggregation
load-sharing
criteria.
link-aggregation load-sharing
mode { destination-ip |
destination-mac | destination-port
| ingress-port | source-ip |
source-mac | source-port } *
By default, the system selects the global load
sharing criteria according to the packet type.
In system view, the switch supports the following load-sharing criteria and combinations:
• Load-sharing criteria automatically determined based on the packet type
• Source IP address
• Destination IP address
To Next Page
Loading...
Need help?
General