Setting Up a Tower System 11-5
Writer: Karen Williams Saved by: Rebecca Wiggins Saved date: 02/17/98 10:11 AM
Part Number: 203118-001 File name: CH11
4. Place the computer left side down on the docking rail
1
of
the tower stand. If the preset width of the tower stand is
the correct setting for your computer, the weight of the
computer will close the hinged panel
2
flush against the top of
the computer.
NOTE: If the hinged panel does not close flush against the top
of the computer, refer to “Adjusting the Width of the Tower
Stand,” next in this chapter.
5. Slide the computer toward the rear of the expansion base until
the docking connector on the computer
3
comes into contact
with the docking connector on the expansion base
4
. This
activates the motorized docking mechanism, which pulls the
computer into a fully seated connection.
Sliding the Computer into the Desktop Expansion Base
To Next Page
Loading...
