3-2 Getting Connected
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/27/98 10:55 AM
Part Number: 203118-001 File name: Ch03.doc
Connecting an External Device to the System
To connect an external device to the system, follow these steps:
1. If the computer is docked turn it off.
2. If the external device is on, turn it off, then disconnect it from
external power.
3. If the external device is connected to the computer,
disconnect it.
4. Connect the external device cable to a connector on the
expansion base.
5. If applicable, plug the power cord of the external device into
an electrical outlet.
6. If applicable, turn on the power switch of the external device.
7. Turn on the system with the computer power switch or the
expansion base power switch.
To Next Page
Loading...
