HP Armada 7300 - Adjusting the Width of an Optional Tower Stand

11-6 Setting Up a Tower System
Writer: Karen Williams Saved by: Rebecca Wiggins Saved date: 02/17/98 10:11 AM
Part Number: 203118-001 File name: CH11
Adjusting the Width of an Optional Tower Stand
You can adjust the width of a tower stand to the thickness of your
computer with preset or custom settings.
■ Width settings are retained by the tower stand. You will not
need to adjust these settings again unless you want to dock a
different-sized computer.
■ Width settings include the width of the expansion base.
Adjusting a Tower Stand to a Preset Width
To adjust a tower stand to the preset width setting for a computer
model listed on the width table 1 , follow these steps:
1. Undock the computer.
2. Find the setting for your computer model on the width table.
3. Align the width selector 2 on the width adjuster 3 with the
preset width setting for your computer by pulling the bottom
of the width adjuster outward, then up or down.
NOTE: The width selector may not align precisely with the
preset width setting.
Aligning the Width Selector with the Preset Width Setting for a Computer in the Armada
7300 Family of Personal Computers