9-4 Installing and Removing an Expansion Board
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 3:27 PM
Part Number: 203118-001 File name: Ch09.doc
Removing the Expansion Slot Cover
!
WARNING:
To reduce the risk of personal injury from hot surfaces,
allow the internal system components to cool before touching them.
CAUTION:
Electrostatic discharge (ESD) can damage electronic
components. Before beginning this procedure, ensure that you are
properly grounded. Refer to Appendix C, “Electrostatic Discharge.”
To remove the expansion slot cover, follow these steps:
1. Find the two expansion slot covers
1 and 2 on the right side
of the expansion base. You can install a PCI expansion board
or an ISA expansion board in either the top or the bottom slot.
Select the slot you want to use.
Identifying the Expansion Slot Covers
To Next Page
Loading...
