HP Armada 7300 - Removing a Half-Height Bay Device

Installing and Removing a Half-Height Bay Device 10-15
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
Removing a Half-Height Bay Device
This procedure explains how to remove a standard half-height
drive from the half-height bay. The procedures for removing an
Armada 7000 Half-Height MultiBay Adapter or an LTE 5000
Half-Height MultiBay Adapter are similar. Refer to the adapter
documentation for specific instructions.
NOTE:
Use slotted Torx T-10 and T-15 screwdrivers.
Accessing the Half-Height Bay Device
To access the half-height bay device, refer to “Installing a Half-
Height Bay Device” earlier in this chapter and follow the
instructions in these sections:
■
First, “Before You Begin.”
■
Second, “Removing the Rear Panel.”
■
Third, “Removing the Top Cover.”
Removing the Drive Cage Assembly
To remove the drive cage and half-height drive, follow
these steps:
1. After you have removed the top cover, remove the three
screws securing the metal drive cage shield to the
expansion base.
Removing the Screws from the Drive Cage Shield