10-16 Installing and Removing a Half-Height Bay Device
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
2. Lift the front edge of the metal drive cage shield and swing it
approximately 45 degrees upward. Then pull it toward you.
The shield pivots along the four tabs extending into the metal
plate at the rear of the drive cage shield.
Removing the Drive Cage Shield from the Desktop Expansion Base
3. After removing the drive cage shield, disconnect the cable(s)
connecting the half-height drive to the expansion base.
4. Lift the drive cage and attached half-height drive out of the
expansion base.
Removing the Drive Cage Assembly from the Desktop Expansion Base
To Next Page
Loading...
