1-6 Getting Started
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 2:50 PM
Part Number: 203118-001 File name: CH01
Connecting the Expansion Base Power Cord
To connect the desktop expansion base to electrical power, follow
these steps:
1. Set the voltage select switch
1
to the voltage supplied by
your electrical service provider. When 115 VAC is selected
2
,
the number 115 is visible on the red portion of the switch.
When 230 VAC is selected
3
, the number 230 is visible.
NOTE: To verify the voltage of your electrical supply, contact
your electrical service provider.
CAUTION: Ensure that the voltage select switch is in the correct
position (115 VAC or 230 VAC). Failure to do so will result in
damage to the equipment.
Setting the Voltage Select Switch
To Next Page
Loading...
