HP Armada 7300 - Using Removable Drives; Customizing the Device Bays

Using Removable Drives 7-1
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 7:14 PM
Pages: 14 Words: 2172 Template: c:\template\ref\ref.dot
Part Number: 203118-001 File name: Ch07.doc
chapter
7
U
SING
R
EMOVABLE
D
RIVES
Customizing the Device Bays
The desktop expansion base has two standard half-height bays.
Both can support any removable device that is supported by
the computer.
■
The right bay is converted to a MultiBay.
❏
A removable Armada 7000 Half-Height MultiBay Adapter
is preinstalled in this bay.
❏
To convert this bay to an LTE 5000 MultiBay, replace the
Armada 7000 MultiBay Adapter with an optional LTE
5000 Half-Height MultiBay Adapter.
❏
To convert this bay to a half-height drive bay, replace the
Armada 7000 MultiBay Adapter with an optional half-
height drive.
■
The left bay is vacant.
❏
To convert this bay to a second MultiBay, install an
optional Armada 7000 Half-Height MultiBay Adapter.
❏
To convert this bay to an LTE 5000 MultiBay, install an
optional LTE 5000 Half-Height MultiBay Adapter.
❏
To convert this bay to a half-height drive bay, install an
optional half-height drive.
■
Expansion base half-height bays as shipped support IDE
devices only. To use a SCSI device externally or in a half-
height bay, install a SCSI controller.
For information about installing a half-height bay device, refer to
Chapter 10, “Installing and Removing a Half-Height Bay Device.”
For information about installing a SCSI controller, refer to
Chapter 9, “Installing and Removing an Expansion Board.”