HP Armada 7300 - Removing an Expansion Board

Installing and Removing an Expansion Board 9-9
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 3:27 PM
Part Number: 203118-001 File name: Ch09.doc
Removing an Expansion Board
Use the following procedure to remove a 32-bit PCI expansion
board or a 16-bit or 8-bit full-length ISA expansion board.
NOTE:
Use a Torx T-15 screwdriver.
1. Disconnect any exterior cables connected to the expansion
board that you plan to remove.
2. Follow the procedures under “Before You Begin” and
“Removing the Rear Panel” in “Installing an Expansion
Board” in this chapter.
3. Remove the screw
1
that is securing the expansion board to
the chassis
2
. This screw will be used later:
■
If you replace the expansion board that you are removing,
you will use the screw to secure the new expansion board.
■
If you do not replace the expansion board that you are
removing, you will use the screw to secure an expansion
slot cover.
Removing an Expansion Board
4. Pull the expansion board straight out.