1-8 Getting Started
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 2:50 PM
Part Number: 203118-001 File name: CH01
Docking the Computer
!
WARNING: To avoid the risk of personal injury, keep fingers and
hands away from the rear of the computer when docking.
CAUTION: Set up a new computer while it is undocked. Do not turn
a computer on for the first time while it is docked.
To dock the computer in the desktop expansion base, follow
these steps:
1. Turn off the computer, if it is on. If you are not sure whether
the computer is off or in Hibernation, turn the computer on,
then shut it down.
NOTE: For information about docking the computer without
shutting it down, refer to “Preparing to Dock the Computer”
in Chapter 4.
2. Turn off, then disconnect any external equipment connected to
the computer. Disconnect cables to any installed PC Cards.
Disconnect the computer power cord.
3. Slide the computer into the expansion base along the left
alignment guide
1
.
4. Push the computer toward the rear of the expansion base until
the docking connector on the computer
2
contacts the docking
connector on the expansion base
3
. This activates the
motorized docking mechanism, which pulls the computer into
a fully seated connection.
Docking the Computer in the Desktop Expansion Base
To Next Page
Loading...
