11-4 Setting Up a Tower System
Writer: Karen Williams Saved by: Rebecca Wiggins Saved date: 02/17/98 10:11 AM
Part Number: 203118-001 File name: CH11
Docking the Computer in a Tower System
!
WARNING: To avoid the risk of personal injury, keep fingers and
hands away from the rear of the computer when docking.
CAUTION: Set up a new computer while it is undocked. Do not turn
a computer on for the first time while it is docked.
To dock the computer in the desktop expansion base in an
optional tower stand, follow these steps:
1. Turn off the computer, if it is on. If you are not sure whether
the computer is off or in Hibernation, turn the computer on,
then shut it down.
NOTE: For information about docking the computer without
shutting it down, refer to “Preparing to Dock the Computer”
in Chapter 4.
2. Turn off then disconnect any external equipment connected to
the computer. Disconnect cables to any installed PC Cards.
Disconnect the computer power cord.
3. Close the computer, if it is open.
To Next Page
Loading...
