Installing and Removing a Half-Height Bay Device 10-17
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
Removing the Half-Height Drive from the
Drive Cage Assembly
1. Remove the four screws attaching the drive cage to the half-
height drive (two screws on each side).
Removing the Screws Attaching the Drive Cage to the Half-Height Drive
2. Remove the half-height drive from the drive cage.
3. Replace the four screws into the sides of the drive. Use any of
the screw holes.
Replacing the Screws in the Half-Height Drive
To Next Page
Loading...
