Setting Up a Tower System 11-7
Writer: Karen Williams Saved by: Rebecca Wiggins Saved date: 02/17/98 10:11 AM
Part Number: 203118-001 File name: CH11
Adjusting a Tower Stand to a Custom Width
To adjust a tower stand to a computer model not listed on the
width table, follow these steps:
1. Undock the computer.
2. Select a trial width setting by aligning the width selector
1
on the width adjuster
2
with any width setting on the width
table
3
.
NOTE: Width settings near the top of the width table are
for thicker computers; settings near the bottom are for
thinner computers.
Identifying the Width Selector, Width Adjuster, and Width Table on the Optional
Tower Stand
To Next Page
Loading...
