Installing and Removing a Half-Height Bay Device 10-5
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
Removing the Top Cover
!
WARNING:
To reduce the risk of personal injury from hot surfaces,
allow the internal system components to cool before touching them.
CAUTION:
Electrostatic discharge (ESD) can damage electronic
components. Before beginning this procedure, ensure that you are
properly grounded. For more information, refer to Appendix C,
“Electrostatic Discharge.”
To remove the top cover, follow these steps:
1. Reposition the expansion base so that the front of the
expansion base is facing you.
2. Remove the alignment tray
1 from the expansion base by
pulling the docking latch 2 forward.
Removing the Alignment Tray from the Desktop Expansion Base
To Next Page
Loading...
