HP LD4201 - Temperature Value (Command: D N); Lamp Fault Check (Command: D P)

Transmission
[d][l][][Set ID][][Data][x]
[Data] Data is always FF (in Hex)
Acknowledgement
[l][][Set ID][][OK/NG][Data][x]
[Data] The data means used hours.
(Hexadecimal code)
31. Temperature value (Command : d n)
To read the inside temperature value.
Transmission
[d][n][][Set ID][][Data][x]
[Data] Data is always FF (in Hex)
Acknowledgement
[n][][Set ID][][OK/NG][Data][x]
[Data] The data is 1 byte long in Hexadecimal.
32. Lamp fault Check (Command : d p)
To check lamp fault.
Transmission
[d][p][][Set ID][][Data][x]
ENWW
Transmission/Receiving Protocol
115
2
n
d
D
r
af
t