ł
Connect the HDMI to HDMI signal cable (not included) to the HDMI/DVI (1) connector on
the rear of the display and the other end to the HDMI connector (2) on the media player/
computer.
Figure 3-22 Connecting the HDMI to HDMI signal cable[Author note:]Create graphic for
HDMI to HDMI?
2. Select an input signal.
Press the INPUT button on the remote control, select the HDMI/DVI input signal, and then press
the OK button to save.
Or, press the SOURCE button on the back of the display, select the HDMI/DVI input signal, and
then press the AUTO/SET button to save.
Connecting LAN (HP LD4210 and HP LD4710 only)
The LAN input on the display can connect to a media player/computer, a router (switch), or an
Intranet. A LAN connection with the display establishes communication between your media player/
computer and the display, which enables the use of the HP Network Sign Manager program running
22 Chapter 3 Setting up the display ENWW
To Next Page
Loading...
