HP LD4201 - Serial No. Check (Command: F Y); S;W Version (Command: F Z); Input Select (Command: X B)

[o][][Set ID][][OK/NG][Data][x]
47. Serial no. Check (Command : f y)
To read the serial numbers
Transmission
[f][y][][Set ID][][Data][Cr]
[Data] Data FF (to read the serial numbers)
Acknowledgement
[y][][Set ID][][OK/NG][Data1]to[Data13][x]
[Data] The data format is ASCII Code.
48. S/W Version (Command : f z)
Check the software version.
Transmission
[f][z][][Set ID][][Data][Cr]
[Data] FFH : Read
Acknowledgement
[z][][Set ID][][OK/NG][Data][x]
49. Input Select (Command : x b)
To select input source for the display.
Transmission
ENWW
Transmission/Receiving Protocol
125
2
n
d
D
r
aft