Icon Main menu Submenu Description
Key Lock Sets up the display so that it can only be used with the remote
control.
This feature can prevent unauthorized viewing.
Set ID Use to assign a unique Set ID NO (name assignment) to each
product when several products are connected for display.
ISM Method Image Sticking Minimalization Method—avoids allowing a
fixed or burn-in image to remain on the screen for a long
period of time.
DPM Select Display Power Management Select—Turns the power saving
mode On or Off.
Power Indicator Sets the power indicator on the front of the display to On or
Off.
DDC-CI To use this feature, select On; to turn off the feature, select
Off.
DFC Digital Fine Contrast—To use this feature, select On; to turn
off the feature, select Off.
Interface Select Sets up network connections.
ł RS-232C—Enables communication via Serial.
ł
Network—Enables communication via Ethernet.
Network Setup DHCP—Allocates and sets up IP automatically.
IP Mode Manual—Sets up IP Address, Gateway, Subnet Mask, and
DNS Server.
Information Contains the Serial No., SW Version (MNT), SW Version
(LAN), IP Address, and MAC Address information.
Factory Reset Resets to the default factory settings.
TILE Tile Mode Enlarges the screen and is also used with several products to
view the screen.
To use Tile Mode, the following must occur:
ł
It must be displayed with several other products.
ł It must be in a function that can be connected to RS-232-
C OUT, RGB OUT, or DisplayPort OUT.
Tile ID Selects the location of the Tile by setting an ID of 1–25.
Natural Mode The image is omitted by the distance between the screens to
be naturally shown.
To use this feature, select On; to turn off the feature, select
Off.
H Size Adjusts the horizontal size of the screen taking into account
the size of the bezel.
36 Chapter 4 Operating the display ENWW
To Next Page
Loading...
