Figure 4-9 The ls Command Screen
12. To return to the MP Main Menu, enter ma at the Command Screen.
13. To exit the MP, enter x at the MP main menu.
Accessing the MP Through a Web Browser
Web browser access is an embedded feature of the MP. The web browser enables access to the
server through the LAN port on the core I/O card. You must configure the MP from an ASCII
console.
NOTE: The MP has a separate LAN port from the system LAN port. It requires a separate LAN
drop, IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, the following information is required:
• IP address for the MP LAN
• Subnet mask
• Gateway address
• Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, follow these steps:
1. Connect to the MP using a serial connection.
2. Configure the MP LAN. See “Configuring LAN Information For the MP” (page 58).
3. To enter the Command Menu, enter cm.
4. To display and set MP remote access, enter sa at the MP:CM> prompt.
60 Cabling and Powering the Server
To Next Page
Loading...
