3. Enable CHAP for the MPX200 iSCSI presented target using the CLI:
a. Enter the set CHAP command.
b. Select the Presented Target the initiator will log in to.
c. Enable CHAP and enter a CHAP secret (for example, hpstorageworks).
4. Enable CHAP for the Microsoft iSCSI initiator.
a. Select the General tab.
b. Click Secret in the middle of the screen.
c. Click Reset.
d. Enter the MPX200 iSCSI Presented Target CHAP secret (for example: hpstorageworks).
e. Click OK.
f. Click Discovery.
• For manually discovering iSCSI target portals:
a. Click Add under Target Portals.
b. Enter the IP address of the iSCSI port of the MPX200.
c. Click Advanced.
d. Select the CHAP Login Information check box.
e. Enter the CHAP secret for the MPX200 discovered iSCSI initiator in the Target Secret
box (for example: CHAPsecret01).
f. Select the Mutual Authentication check box.
g. Click OK.
h. Click OK again and the initiator completes target discovery.
• Using iSNS for target discovery:
a. Click Add under iSNS Servers.
b. Enter the IP address of the iSNS server.
c. Click OK.
g. Click Targets.
h. Select the appropriate target for login.
i. Click Log On.
j. Click Advanced.
k. Select the CHAP Login Information check box.
l. Enter the CHAP secret for the MPX200 discovered iSCSI initiator in the Target Secret box
(for example: CHAPsecret01).
m. Select the Mutual Authentication check box.
n. Click OK.
o. Click OK again and the initiator completes normal login.
MPX200 Multifunction Router 111
To Next Page
Loading...
Need help?
General