readjust_priority
Modifies the priority of serial scheduled jobs. Use this feature if you have more than 256 jobs that
must be executed sequentially. This operation is allowed only if the high priority jobs are completed,
and there is room for shifting the priority values on already configured jobs. This reduces the priority
value of the last job from 256 by the value of the priority of the currently running serial job, and
makes room to configure more serial jobs.
Session: miguser
Example:
MPX200 <1> (miguser) #> readjust_priority
Are you sure you want to adjust the priorities of serially
scheduled jobs that haven't started (y/n): y
Priorities have been successfully re-adjusted.
MPX200 Multifunction Router 241
To Next Page
Loading...
Need help?
General