Figure 110 Information page showing array is licensed
.
Applying an array-based license to a specific array in the CLI
If you have purchased array-based licenses and installed the licenses in the MPX200, follow these
steps to license a specific array for data migration. For every array that is licensed, one license is
consumed.
1. Open a miguser session using the following command:
miguser start -p migration
2. To apply a license, enter the following command (see “set array” on page 194):
set array
3. At the prompt, Do you want to apply array license (yes/no), enter yes.
The following example shows the set array command.
MPX200 (miguser) #> set array
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId Symbolic Name Target Type
----- --------------------------------- --------------- -----------
0 50:00:1f:e1:50:0a:e1:4c, 01-2b-00 HP HSV200-0 Unknown
1 50:00:1f:e1:50:0a:37:18, 01-24-00 HP HSV210-1 Unknown
2 50:06:01:69:41:e0:18:94, 01-2d-00 DGC RAID-2 Unknown
Offline Data Migration186
To Next Page
Loading...
Need help?
General