5. Select the Connected Targets tab, and then click the Toggle Start-Up button for each target listed
so the targets start automatically (Figure 50).
Figure 50 Connected Targets tab
.
Installing and configuring the iSCSI driver for Red Hat 5
NOTE:
The iSCSI driver package is included but is not installed by default. Install the package
iscsi—initiator—utils during or after operating system installation.
To install and configure the iSCSI driver for Red Hat 5:
1. Use the iscsiadm command to control discovery and connectivity:
# iscsiadm –m discovery –t st –p 10.6.0.33:3260
2. Edit the initiator name:
# vi /etc/iscsi/initiatorname.iscsi
3. Start the iSCSI service:
# service iscsi start
MPX200 Multifunction Router 73
To Next Page
Loading...
Need help?
General