Supported IP network adapters
For the latest information on IP network adapter support, see the product release notes or SPOCK at
http://www.hp.com/storage/spock. You must sign up for an HP Passport to enable access.
Table 7 lists the IP network adapters supported by the MPX200.
Table 7 Supported IP network adapters
Network interconnectOperating system
All standard GbE NICs/ASICs supported by AppleApple Mac OS X
All standard 1 Gbe or 10 GbE NICs/ASICs and TOE NICs supported by
HP for Windows 2008 and 2003
QLogic iSCSI HBAs
Microsoft Windows Server 2008,
2003, Hyper-V
All standard 1 Gbe or 10 GbE NICs/ASICs supported by HP for Linux
QLogic iSCSI HBAs
Red Hat Linux, SUSE Linux
All standard GbE NICs/ASICs supported by Sun
Sun Solaris
All standard 1 Gbe or 10 GbE NICs/ASICs supported by HP for VMware
QLogic iSCSI HBAs
VMware
IP network requirements
HP recommends the following:
• Network protocol: TCP/IP IPv6, IPv4, Ethernet 1,000 Mb/s or 10 GbE
• IP data—LAN/VLAN support with less than 10 ms latency; maximum of two VLANs per port, one
VLAN per protocol
• IP management—LAN/WAN support
• Dedicated IP network for iSCSI data
Setting up the iSCSI initiator
This section explains how to set up the iSCSI initiator.
Windows Server iSCSI initiator
For Windows Server 2008, the iSCSI initiator is included with the operating system. For Windows
Server 2003, you must install the iSCSI initiator.
MPX200 Multifunction Router 55
To Next Page
Loading...
Need help?
General