target rescan
Scans the target ports to see whether one or more data LUNs are exposed to the router ports from
the target. This command causes the router to create an array entity for the target ports through which
the router is able to see data LUNs. The router deletes those ports from show targets output (see
“show targets” on page 235).
Session: admin
Example:
MPX200 (admin) #> target rescan
Scanning Target WWPN 00:00:02:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 00:00:01:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 00:00:03:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 50:08:05:f3:00:1a:15:11
Target Rescan done
Scanning Target WWPN 50:08:05:f3:00:1a:15:19
Target Rescan done
Target Re-Scan completed
MPX200 Multifunction Router 237
To Next Page
Loading...
