HPE ProLiant ML110 Gen10

Power supply specifications
Depending on the installed options and/or the regional location where the server was purchased, the server is configured
with one of the following power supplies:
• ATX 350W non-hot-plug power supply
•
ATX 550W non-hot-plug power supply (88% eiciency)
• ATX 550W non-hot-plug power supply (92% eiciency)
• HPE 500W Flex Slot Platinum Hot-plug Low Halogen Power Supply
•
HPE 800W Flex Slot Platinum Hot-plug Low Halogen Power Supply
CAUTION: Check the system and power supply input ratings before powering up the server.
ATX 350W non-hot-plug power supply
Specification Value
Input requirements
Rated input voltage
100 VAC to 240 VAC
Rated input frequency 50 Hz to 60 Hz
Rated input current
45 A at 100 VAC
19 A at 240 VAC
Maximum rated input power
437 W at 100 VAC
416 W at 240 VAC
BTUs per hour
1491 at 100 VAC
1419 at 240 VAC
Power supply output
Rated steady-state power
350 W at 100VAC to 240VAC
Maximum peak power
385 W at 100VAC to 240VAC
ATX 550W non-hot-plug power supply (88% eiciency)
Specification
Value
Input requirements
Rated input voltage
100 VAC to 240 VAC
Rated input frequency 50 Hz to 60 Hz
Table Continued
Specifications 131