HPE ProLiant ML110 Gen10

CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripherals cables from the server.
4. If a Kensington security cable is installed, disconnect it from the rear panel. See the security cable documentation for
instructions.
5. Do one of the following:
• Server in rack mode:
Remove the server from the rack.
• Server in tower mode: Position the tower server for hardware configuration.
6.
Remove the access panel:
a.
Loosen the access panel thumbscrews.
b.
Slide and remove the access panel from the server.
Remove the front bezel
Procedure
1. If the bezel is locked, power down the server.
2. Remove all power:
Removal and replacement procedures
34