9. Disconnect the energy pack cable from the system board connector, and then remove the energy cable from the cable
clip.
To replace the component, reverse the removal procedure.
Removing and replacing the system board
Removing the system board assembly
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-30 Torx screwdriver
• T-15 Torx screwdriver
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
• Server in rack mode:
Remove the server from the rack.
• Server in tower mode: Position the tower server for hardware configuration.
5.
Remove the access panel.
Removal and replacement procedures
83
To Next Page
Loading...
