HPE ProLiant ML110 Gen10

a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. If the front bezel is locked by the internal locker,
remove the access panel.
4. Open and remove the front bezel:
a. Slide up the internal locker.
b. Open the front bezel.
c. Remove the front bezel.
Remove the PCI air bale
Procedure
1.
Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
• Server in rack mode:
Remove the server from the rack.
• Server in tower mode: Position the tower server for hardware configuration.
5.
Remove the access panel.
6. Remove the PCI air bale.
Removal and replacement procedures
35