HPE ProLiant ML110 Gen10

10. Remove the M.2 SSD.
To replace the component, reverse the removal procedure.
Removing and replacing the M.2 SSD
Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
Procedure
1.
Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
• Server in rack mode:
Remove the server from the rack.
• Server in tower mode: Position the tower server for hardware configuration.
5.
Remove the access panel.
6. Remove the PCI air bale.
7.
Remove the system air bale.
8. Remove the M.2 SSD enablement board.
9. Remove the M.2 SSD.
Removal and replacement procedures
58